Dalapro Design TopCoat

Used in combination with Dalapro Design and only in dry spaces indoors. Both material and substrate must have a temperature of +10°C – +25°C.

Apply Dalapro TopCoat using a foam rubber roller or a short-bristled paint roller in a consistent, thin coating. Repeat the application until you have achieved the desired end result. Normally requires at least two coats. The drying time is approximately 2–3 hours. Covers approximately 8 square metres per litre.

Preparations: Remove dust from the surface to be treated. Cover the floor, mask skirting boards, door frames and, if necessary, cornices.
Step 1: Apply Dalapro Design TopCoat using a foam rubber roller or a short-bristled paint roller in a consistent, thin coating. Quickly dab clean any run-off using a cloth. Otherwise there is a risk that this will be visible in the finished job. Allow to dry.
Step 2: Repeat the application until you have achieved the desired end result. Normally requires at least two coats.
If you want a stronger surface with a glossier finish, you can apply another coating of Dalapro TopCoat. Dalapro TopCoat can also be applied with a pressure sprayer. In that case it should be diluted with 1 dl water per 5 dl Dalapro TopCoat. Recommended distance from wall: 30–40 cm. Make sure you have a good sprayer pattern before you start.